- Messages
- 260
- Reaction score
- 6
- Points
- 28
MyPhone myT3 DTV
At first, "Stuck on Boot Logo" lang issue ng unit. I tried to clear/wipe cache/data but still stuck on boot logo.
I tried using Miracle box cracked version pero after reading ng phone info nagka-error sa dulo.
When I tried to power on the unit, ayun jackpot... NO POWER, Unrecognized devices sa PC and No response sa charging.
In this case, hindi ako makakapagflash kung hindi marecognize ng maayos ang unit sa pc. After searching for a solution, we need to short 2pins ng charging pin para madetect uli sya ng PC.
Step 1: Fixing Dead Boot / Unrecognized by PC:
Requirements:
Method 1:
Method 2:
After doing this method, madedetect na ng PC ang unit at pwede na rin ma-power on ang unit.
Step 2: Flashing Firmware:
Requirements:
Flashing with SPD UpgradeDownload Tool:
It took me 10mins on 1st boot up. Then normal na uli after that.
CONSTRUCTION | |
---|---|
FORM FACTOR | Candy Bar |
USABILITY | |
DISPLAY RESOLUTION | 600x1024px |
DISPLAY SIZE | 90x154mm (3.54x6.06") ~170PPI |
DISPLAY DIAGONAL | 7.0" |
DISPLAY TYPE | 16M IPS |
INPUT | Capacitive Touchscreen |
OS | Android OS, v7.0 |
VIBRATION | Available |
HARDWARE | |
CHIPSET | Spreadtrum SC7731 |
PROCESSOR | 4 Cores @ 1.2GHz ARM Cortex-A7 |
GPU | Mali-400MP |
RAM | 1GB |
INTERNAL MEMORY | 8GB |
EXTERNAL MEMORY | microSD |
CAMERA RESOLUTION | 5 Megapixel |
CAMERA FLASH | LED |
FRONT CAMERA | 5 Megapixel |
OTHER FUNCTIONALITIES | Proximity Sensor |
BATTERY CAPACITY | 2500mAh |
CONNECTIVITY | |
WIFI | Wi-Fi 802.11 b/g/n |
USB | 2.0 |
BLUETOOTH | v4.0 |
POSITIONING SYSTEM | Integrated GPS |
AUDIO OUTPUT | 3.5mm Jack |
CELLULAR NETWORK | |
SIM CARDS | 2x Micro |
GPRS | Available |
EDGE | Available |
At first, "Stuck on Boot Logo" lang issue ng unit. I tried to clear/wipe cache/data but still stuck on boot logo.
I tried using Miracle box cracked version pero after reading ng phone info nagka-error sa dulo.
When I tried to power on the unit, ayun jackpot... NO POWER, Unrecognized devices sa PC and No response sa charging.
In this case, hindi ako makakapagflash kung hindi marecognize ng maayos ang unit sa pc. After searching for a solution, we need to short 2pins ng charging pin para madetect uli sya ng PC.
Step 1: Fixing Dead Boot / Unrecognized by PC:
Requirements:
- Soldering skill
- Common Sense
Method 1:
- Open the back cover of the SIM and memory slot, remove the SIM/SDcard and remove the screw, then remove the casing.
- Carefully remove the ribbon cables and unscrew the board to see the charging pin from the other side of the board.
- Merong itong 5 pins and you only need to short(solder) ang 4th and 5th pin.
- Alin dun? Sa dulo, merong nakasulat na GND or Ground. Yun ang 5th pin. Kapag naisolder nyo na, pwede na i-assemble uli at detected na uli sya ng PC.
Method 2:
- For this method, hindi na need i-disassemble ang unit. Pwede rin yung dulo ng charger mismo.
- Merong mga mumurahing charger na madali baklasin yung pinakadulo. Pag meron ka nito, i-solder mo lang din yung 5th and 4th pin.
- Alin dun? Syempre yung dulo rin yung 5th pin, nasa side ng Ground or ng Black wire.
After doing this method, madedetect na ng PC ang unit at pwede na rin ma-power on ang unit.
Step 2: Flashing Firmware:
Requirements:
- SPD Drivers
- Research/UpgradeDownload Tool
- myT3 DTV firmware
- All files nandito na (Click here)
Flashing with SPD UpgradeDownload Tool:
- Install SPD Drivers
- Open Flash Tool and load tha pac file and Click start button.
- While hold Volume down button of your unit, insert the usb cable.
- Kapag nakita mo na downloading na sa tool, pwede mo na release yung volume down button.
- Wait until status is Finish then remove the cable.
It took me 10mins on 1st boot up. Then normal na uli after that.
Last edited: