Share ko lang po ang ginawa kong Active Subwoofer using Bandpass enclosure nung tuesday.
DIY Passive Bandpass Subwoofer / Active Bandpass Subwoofer INDOORS
Tools :
Coping Saw
Plywood Saw (for plywood, crosscut saw or rip saw is good to use)
Measuring Tape
Hammer
Mallet
Try Square (iskwala)
Blower (kung ntatagan ka sa normal na proseso ng pagpapatuyo ng wood glue at rugby)
Materials :
Sanded G2S Marine Plywood - Wood Thickness is 3/8
Port (tube sa raon) - Diameter is 2", Length is 3"
PVC Pipe - Diameter is 2", Length is 21"
-total combined length is 22"
Vinyl
Corner Protectors (di ako sure kung ano tawag )
Wood Glue
Magic Pillow Cotton
Drywall Screws
Nails (1")
Rugby
Driver
(in the tryouts i use DAI-CHI 100w SUBwoofer) as shown in the picture.
final/actual subwoofer installed is pyle 5.25" 150w / 300w max. (midbass ata ito; bigay ni utol from U.S)
Amplifier/System
My custom built amplifier derived from amplifier inside the Xenon AX-302 Box.
reference image:
a blog for Xenon ax-302
Overall ang built na ito ay replica/improved version(because of custom amplifier) ng Xenon AX-302.
ginaya ko at inimprove ko ang system na nabanggit. {cancelations, etc}
Box nung sub ginaya at inimpruv ko din sa best na kaya ng mga available materials na available.
ito nung simula :
late ko na nalaman mga calculators dito pero pa rin. eto yung sa akin pang bandpass
-->AJDESIGNER
-->BANDPASS
-->CALCULATOR
Sukat ng Box (outer)
H = 32"
W = 22"
D = 35"
Division:
Rear depth = 22"
Front depth = 13"
---------------------------------------------
Heto na ang Speaker box nung trial na.
Deep ang Bass at Masakit sa dibdib ang kick. INDOORS ha.
Note : Hindi po basta-basta ang pagbuo ng speaker box/enclosure lalo na itong bandpass design.
sir pa comment ha..gumgawa din ako ng box..tingin ko mas lalakas pa yan at gaganda tunog kung mdf ginamit mo..kahit 3/4 lang ang kapal..tips lang pra sa gustong mag try nag box na ito..nakagawa na rin ako nito dati..same design din..maganda tunog nit..lupit!!!