- Messages
- 7
- Reaction score
- 0
- Points
- 16
FACTORY RESET security code 12345 using PHOENIX TEST & SERVICE SOFTWARE and USB cable
i forgot my NOKIA X2-01 security code.
i can't use my phone.
my PC can't detect USB because SECURITY CODE is locked.
keypad is locked.
FACTORY RESET NOKIA X2-01 (reset security code to 12345)
using PHOENIX TEST & SERVICE SOFTWARE
1. how to make USB nokia X2-01 to be detected by your PC.
= connect a RESISTOR (about 5K ohms) between the BATTERY TERMINALS = BS1 (center) and GND (-).
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478264.jpg
in my case, i don't have 5kOhms. i used resistors in series but only about 3.8kOhms total)
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478257.jpg
i used old cd-rom audio cable and used the terminal to connect to the battery terminals BS1(center) and GND (-).
i soldered the series resistors to the other end of the audio cable.
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478248.jpg
2. PHOENIX Test & Service Software INSTALLATION
= before installing PHOENIX
remove all NOKIA related softwares, PC SUITE, SOFTWARE UPDATER, CONNECTIVITY CABLE
=disable all anti-virus
=PROCEED to PHOENIX SETUP (takes time)
3. insert micro USB cable to your NOKIA X2-01 and connect to PC
= wait for all USB Drivers to be detected
= click phoenix
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478266.jpg
= SCAN PRODUCT
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478268.jpg
= RM-709
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478236.jpg
= TESTING
= FACTORY SETTINGS
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478238.jpg
=FACTORY SET FULL
=WRITE
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478237.jpg
= switch to test mode ? NO
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478265.jpg
= write to phone ? YES
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478239.jpg
= SUCCESSFUL
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478267.jpg
=PHOENIX VERSION
http://pic100.picturetrail.com/VOL1164/13357859/23784610/396478240.jpg
= disconnect USB from PC.
= remove resistor
= switch on your NOKIA X2-01
= enter SECURITY CODE === 12345
YOU CAN DO IT.
Sir tanong ko lang po. Pano po na recognized ng phoenix nyo yung RM-709. Sakin po kasi ayaw mag recognize nung RM-709. Pano po kaya gagawin ko? Newbie here. TIA