ang problen nyan na modem mo ay firmware palitan ng firmware ok na uli yan yang polko laging nagluluko
try mo gawin ito
B315s Restoration from soft-brick (Fully Restore)
Fully Restore your soft-bricked modem with this tutorial. (from No Service to Power LED Only problem)
A complete niggy (newbie) guide by reimu. (actually i just ripped this from russian gsm? forum 4pda, and translated it.)
Download the files here.
Code:
https://mega.nz/#!HlkWmBoB!H_8tBG_P5vn_f_k3GemPW3e17BG7SuoCD93eG-A7-N8
https://www.mediafire.com/?8w0nnayu89wx46e
Password : Gensokyo$!!reimu
Question :
Can I change to any firmwares available in this forum?
a : Yes you can, currently using mine with modified 21.321.03.01.973 Firmware installed.
Prerequisites :
Metal conductor for jumping BOOT and GND pin on the board.
Files required for doing this tutorial. (Firmware, balong_flash, and usbdloader.bin)
Procedure :
Contact BOOT and GND pin, and then plug the Power Adapter to the modem. If the Power Light lit after connecting the Power Supply, repeat the steps. If not, then proceed to the next step.
Click image for larger version.
Name: 35ksrjs.jpg
Views: 762
Size: 425.3 KB
ID: 1210092
Reference Picture of BOOT pin.
Connect USB Male to Male Cable to the Modem and to your Computer, It should show a COM PORT of HUAWEI Mobile Connect - 3G PC UI Interface.
Run commitblocks.cmd, and select option number 1.
Fastboot should respond to the Command Prompt with "OK" status, if it respond with a "FAIL" status. Repeat the steps.
After deleting nvram image of your modem, turn it off then repeat the first step above for jumping BOOT and GND pins.
Once you get to work the BOOT and GND pin again and it shows a HUAWEI Mobile Connect - 3G PC UI Interface COM PORT at Device Manager.
Run load_usbdloader.cmd. The script will automatically load usbdloader to the modem, once finished it will show a new COM PORT named HUAWEI Mobile Connect - 3G Application Interface on Device Manager.
Run B315s-22_Update_21.311.05.00.00_M_01.01_nvr.exe and click Start. When the Firmware Upgrader Program found the COM PORT of your device, device LED lights will lit up. Wait until the Firmware Upgrader completes downloading the software to your modem, and also wait for the modem to reboot itself.
Once you finish flashing the firmware to your modem, unplug the USB Male to Male cable then do a power cycle to your device (Unplug and replug the power adapter)
Plug LAN Cable to your modem and go to 192.168.8.1, if a Generic WEBUI of Huawei shows up. Congratulations, you've just successfully revived your modem from "death".
Thanks to rust3028 of 4pda.ru for the files.