- Messages
- 2,067
- Reaction score
- 4
- Points
- 28
Invalid imei after flashing cfw?
Invalid imei after hard reset?
Easiest solution.
Kung naka pag flash kayo ng cfw sa phone ninyo it means rooted ang mtk phones ninyo.
First, copy/grab/get/take note of your imei serial numbers (especially on dual sim phones)
Second, download mobile uncle tools. (Google ninyo nalang
After mainstall ang mobile uncle tools, open it.
Engineer mode>
engineer mode (mtk)>
connectivity tab>
cds information>
radio information>
>phone 1
Under "at+"
Add this line
AT +EGMR=1,7,"IMEI1"
Send AT command
Same goes to:
>phone 2
Under "at+"
Add this line
AT +EGMR=1,10,"IMEI2"
Send AT command
REBOOT
========
If you got an error:
"This Command is not allowed in UserBuild" this normally occur while trying to change the imei of your Mtk devices base on Android version 4.4 kitkat.....
just toy to figure out a simple way to bypass this annoying massage when trying to change your imei
>>in line ""AT +EGMR=1,7,"IMEI_1" YOU MUST ENTER SPACE BETWEEN AT and +, so not AT+EG... but AT +EG
or
>>in line ""AT+EGMR= 1,7,"IMEI_1" YOU MUST ENTER SPACE BETWEEN = And 1
=========
Not rooted?
Grab your phone's stock rom and flash it via sp flash tool. Do not forget to take note or back up your imeis.
Invalid imei after hard reset?
Easiest solution.
Kung naka pag flash kayo ng cfw sa phone ninyo it means rooted ang mtk phones ninyo.
First, copy/grab/get/take note of your imei serial numbers (especially on dual sim phones)
Second, download mobile uncle tools. (Google ninyo nalang
After mainstall ang mobile uncle tools, open it.
Engineer mode>
engineer mode (mtk)>
connectivity tab>
cds information>
radio information>
>phone 1
Under "at+"
Add this line
AT +EGMR=1,7,"IMEI1"
Send AT command
Same goes to:
>phone 2
Under "at+"
Add this line
AT +EGMR=1,10,"IMEI2"
Send AT command
REBOOT
========
If you got an error:
"This Command is not allowed in UserBuild" this normally occur while trying to change the imei of your Mtk devices base on Android version 4.4 kitkat.....
just toy to figure out a simple way to bypass this annoying massage when trying to change your imei
>>in line ""AT +EGMR=1,7,"IMEI_1" YOU MUST ENTER SPACE BETWEEN AT and +, so not AT+EG... but AT +EG
or
>>in line ""AT+EGMR= 1,7,"IMEI_1" YOU MUST ENTER SPACE BETWEEN = And 1
=========
Not rooted?
Grab your phone's stock rom and flash it via sp flash tool. Do not forget to take note or back up your imeis.
Attachments
Last edited:
