Modification from animalitycomz shell commands:
-------------------------------
-----Welcome to ATP Cli------
-------------------------------
Login: wimax
Password:
ATP>cmd SetUserMode super <enter>
ATP>shell <enter>
/ # cd bin <enter>
/bin #
/bin # telnetd <enter>
/bin #
/bin # equipcmd setAssemblyenable <enter>
Enable assembly success/bin #
/bin # equipcmd 11 78:1D:BA:XX:XX:XX (or use this command equipcmd setmacaddr
78:1D:BA:XX:XX:XX)
Set HWaddr success/bin #
/bin #
display ouinum ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ success/bin #
/bin #
/bin # equipcmd setserialnum 500810118xxxxxxx
Set sn success/bin #
/bin #
/bin # equipcmd swversion display
software version: V100R001PHLC08B025
pcb version: 16843009
cfe version: BM622i
display version success/bin #
/bin # exit <enter>
ATP>logout
logout from configuration console.
Disconnect from server
Connection to host lost.
Press any key to continue...<enter>
Welcome to Microsoft Telnet Client
Escape Character is 'CTRL+]'
Microsoft Telnet> o
( to ) 192.168.254.1
Connecting To 192.168.254.1...
Microsoft Telnet>q <enter>
Z:\Documents and Settings\animaltycomplex>exit <enter>
login to: http://192.168.254.1
Then Reboot to refresh config.
- OR -
try these commands, after telnetd function.. but first look for the exact DEVICE name..
===
- ip link set address NEWMAC dev eth0 (NEWMAC == xx:xx:xx:xx:xx:xx) and eth0 is the DEVICE
- ip link show eth0 ( this command is to verify if the MAC switched)
===
if not successful, reason:
you may not be able to change the MAC address while the link is
up...try:
- svi dhclient stop
- net stop
- ip link set eth0 address xx:xx:xx:xx:xx:xx <== newmac and eth0 is the Device name
- net start
- svi dhclient start
- ip link show eth0
====
to set DEVICE up or down, you can also use:
- ip link set DEVICE up <=== set device up
- ip link set DEVICE down <=== otherwise
- ifconfig up / down
- ifdown
- ifup
====
feedback if successful ...
boosing pd lagyan ng screenshot?
hit kita ng thanks
)
