unable to format USB password protected

[yakuini1977]

Dear help,

unable to format my 16GB kingston Flash drive (password protected) meron pa bang way to format pag nka protected na sya..

i did the following..

edit from REGEDIT
attrib
diskpart

but still cannot format..

please help..

thank you

Yakuini

 

[agundayalbert]

tol gawin mo lahat ito:

Click start
then run regedit
go to this directory HKEY_LOCAL_MACHINE\SYSTEM\Currentcontrolset\control\
if you can't find StorageDevicePolicies under control folder
then make some new one. Follow this steps:

step 1:
go to this directory HKEY_LOCAL_MACHINE\SYSTEM\Currentcontrolset\control\
again and right click control folder

step 2:
select new, then click key and rename the new key #1 folder into
StorageDevicePolicies

step 3:
right click StorageDevicePolicies folder and select new DWORD(32-bit) Value
for 32-bit Operating System and select new DWORD(64-bit) Value
for 64-bit Operating System

step 4:
rename dword newer folder into WriteProtect, then double click WriteProtect
and change the value data into 0 with hexadecimal base, Then close regedit

step 5:
open my computer and refresh it 5 times without do anything to your usb, and
properly eject your flash drive

step 6:
plug in your usb again into your computer and format it using exfat instead of fat32

hope will help you....

 

[lordovy]

ginawa ko narin yan pero di nagana

 

[paparak]

pano process mo sa Diskpart?

 

[taurexn]

kung na-try mo yun suggestion nila ts at hindi umobra yun diskpart o hard format, malamang may sira na yan usb drive mo...

 

[krixer]

diskpart yan boss

 

[rommenickreyeselan]

ganyan din ngyari skn TS ginawa qn lahat pero sira na tlga...

 

[pengzky43]

Boss: baka may mali sa process mo... check mo ulit.... eto yung suggestion ko....


1 Click LOgo Screen..
2 type diskpart then Run As Administrator...
3 sel disk x -----(yung x={0,1,2,3,4,5,6...})
4 sel vol y -----(yung y={0,1,2,3...} yung # ng USBdrive mo....)
5 format recommended
Hintay kalng.....
pag hindi parin...
6 clean
7 create partition primary
ok nayan....


MEthod2:



1 LOGO + r ----run command
2 DISKMGMT.MSC
3 Right click yung area ng disk mo...then delete volume or format...
4 choose yung gustmo mong config at FileSystem...
Thats All....Graphical naman yan... Common Sense Na Lng po yung procedures.....



Thank you...
<Cyber0ne>